Hi i have tried for about an hour trying to figure out how to unlock the unifi ap from the wall mounting bracket to remove and move the device.
Ubiquiti unifi remove wall mount.
Hi i have mounted a unifi ap ac onto the ceiling mounting bracket with the cat6 cable connected.
One of the ports provides poe for powering and connecting an 802 3af device to the network.
I m new to the world of ubiquiti.
I just took the plunge to convert to a full unifi system currently using two asus routers.
For a ceiling mout will you get a decent signal on the.
So if i were to place one on a ceiling i d want it near the center of the area i want to cover this is not necessarily the center of the entire area facing down.
For a home installation is there any difference between the two.
Is there a pin somewhere i need to depress to release the lock.
What are the pros and cons of the two options.
I guess this depends somewhat on the directionality if any of the radio.
I ve been using a us 8 60w switch for a week now and setup a raspberry pi to run the cloud key software.
I am afraid to use too much force and breaks the 4 plastic.
In order to release an ap slide a flat thin object firm zip ties are the community favorite into the locking notch of the ap opposite of the cable feed hole and twist counterclockwise.
If i were to wall mount i d want to mount it at the edge and facing inward of the area i want to cover.
Now i need to unmount to touch up the hole i have drilled for the cat6 cable but the unifi ap ac is so tightly slotted into the bracket.
If you orient them on a wall they will radiate in the vertical.
This is another thing that the manual is silent on.
The round unifi access points have a locking feature to ensure a secure and anti theft hold to the wall mount.