It covers installation of torsion springs step 14 of the manual.
Torsion bar garage door installation instructions.
With locking pliers clamped on the torsion tube winding bars are used to wind the springs tighter to increase tension.
Adjustments should be made in 1 4 turn increments.
When two springs are used both sides should be adjusted the same.
Flying off can damage cars other property or even a person who is in the garage when it happens.
For torsion spring installation go to page 7 of the door installaton instruc tions.
Insert the bolts in the stationary cones of the new torsion spring and insert the bolts in the slots on the spring anchor bracket.
To adjust torsion spring tension the door is locked in the down position.
Torsion spring brackets should be firmly mounted to the wooden header above the door.
When torsion springs break they don t fly off like extension springs can.
Torsion springs 1 6 19 w a r r a n t y 3 1 read this manual carefully and observe all warnings when installing operating or maintaining your garage door.
After the springs are installed proceed to page 6 step 35 of the door installation instructions to finish the installation.
Roller track support brackets and the opener should be securely bolted to the rafters.
8 align the lhr rear upper track to the standard track so that the gap between the lhr front and lhr rear upper tracks is not greater than 1 8.
Steel residential garage door installation instructions and maintenance 1 and 2 layer construction in this manual you will find safety information how to prepare the opening installing the new door painting maintenance and replacement parts.
For instructions on how to install a new garage door opener see how to install a garage door opener.
Read the information in both.
Securely mounted hardware and rails.
For extension spring installation go to page 7 of these instructions.
Installation of rear torsion spring system.
Supplemental instructions torsion spring installation this is a supplement to the residential garage door instructions referred to as the manual.
Make sure that the bearing is inside the stationary cone.
Follow the track bolt placement figure.
Tension is reduced by removing turns.
Mark the position on the standard track through the lower hole in the front splice plate connected to the lhr rear upper track.
For all other information and safety warnings concerning your garage door see the manual.